Hall Current Sensor Module ACS712 model 30A

250.00

5 in stock

SKU: YB-SNSR-19006 Category: Tag:

Description

Product Description:

This is a breakout board for the fully integrated linear ACS712 current sensor. The sensor gives precise current measurement for both AC and DC signals. Thick copper conductor and signal traces allows for survival of the device up to 5 times over current conditions. The ACS712 outputs an analog voltage output signal that varies linearly with sensed current.

ACS712 is based on Hall detection principle, please try to avoid the magnetic field, when using as it may impact the reading accuracy.

Features:
Current sensor chip: ACS712ELC-30A.
Pin 5V power supply, on-board power light.
The module can be measured plus or minus 30A current, Corresponding analog output 66 mV/A.
No test current through, the output voltage is VCC/2.
PCB size: 31(mm) x13(mm).

Technical specification:
Low-noise analog signal path
Device bandwidth is set via the new FILTER
5 ?s output rise time in response to step input current
80 kHz bandwidth
Total output error 1.5% at TA = 25?C
Small footprint, low-profile SOIC8 package
1.2 m? internal conductor resistance
2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
5.0 V, single supply operation
66 to 185 mV/A output sensitivity
Output voltage proportional to AC or DC currents
Factory-trimmed for accuracy
Extremely stable output offset voltage
Nearly zero magnetic hysteresis
Ratio metric output from supply voltage

Reviews

There are no reviews yet.

Be the first to review “Hall Current Sensor Module ACS712 model 30A”

Your email address will not be published. Required fields are marked *